Alabama DMV Practice Test 2

Use low beam headlights when driving in rain, snow, sleet, or fog. High beam headlights in adverse weather conditions lower visibility by reflecting off the precipitation and back into the driver’s eyes.

Warning signs are usually yellow with black markings. This sign warns that your current road ends at an intersection straight ahead. Slow down and prepare to yield or stop before turning right or left.

Before changing lanes, check for drivers trying to pass you who may be trying to enter the same lane as you. Look over your shoulder to check your blind spot. You should never attempt to pass or otherwise change lanes in an intersection.

Expect a train on any track, at any time, traveling in either direction. If you need to stop after crossing the tracks, wait until you can completely cross the tracks before proceeding. Make sure your vehicle clears the tracks before you stop.

A five-sided yellow or yellow-green sign alerts drivers to either a school zone or school crossing.

A driver should watch beside, ahead, and to the rear of their car. To be a good driver, you must know what is happening all around your vehicle.

Excessive speed is one of the most common contributing factors to vehicle crashes. Excessive speed does not save time and often leads to high-risk decision-making.

Slow down before you enter a curve because you do not know what may be ahead. Braking on a curve may cause you to skid.

Before merging into interstate traffic, you should identify a gap, accelerate to the speed of traffic, and signal. Merge into the gap when it is safe to do so. Be alert to other traffic and do not expect other drivers to clear the lane.

You must never turn around while on or near any curve or hill. You may not be able to see oncoming traffic or pedestrians and may cause a collision.

This sign marks a one-way road, entrance, or exit. If you are facing this sign, traffic is coming toward you. Turn around if you are driving toward this sign.

When entering and driving through a work zone, slow down and be prepared to stop. Obey posted speed limits and be alert to conditions around you. Workers could be present.

This sign warns that the road ahead becomes slippery when wet.

After a collision, if no one has been injured or killed and you can safely do so, you should move your vehicle out of the traffic lane.

Warning signs are usually yellow with black markings. This sign warns that the divided highway ends ahead. Prepare to change lanes or shift lane position.

A round sign always indicates that you are approaching a railroad crossing.

Before beginning a right turn, use the appropriate signal to give surrounding drivers adequate notice of your intentions. Slow down and approach the intersection from the right lane, staying as close as is practical to the right curb or edge of the roadway.

If there are oncoming vehicles to your left and a row of parked vehicles to your right, the best thing to do is to split the difference. Steer a middle course between the oncoming cars and the parked cars.

Warning signs are usually yellow with black markings. They alert you to conditions that are immediately ahead. This sign warns drivers that the number of lanes is reduced ahead and that traffic should merge left.

If you are entering interstate traffic from an entrance or acceleration ramp, yield to drivers already on the interstate. Merge safely into traffic when you are able to do so.

When driving a vehicle equipped with an Anti-Lock Braking System (ABS), a driver should press the brake pedal firmly when stopping on a snowy or icy surface. The ABS will pump the brakes more rapidly than a driver would be able to.

When approaching a pedestrian who is using a white cane or guide dog while crossing the street, you must stop until the person is well away from your path of travel. Always yield the right-of-way to blind pedestrians.

Only the passage of time can remove alcohol and its impairing effects from the body.

When passing another vehicle on its left, you may move back into the right lane when the headlights of the passed vehicle can be seen in your rearview mirror. Always signal before changing lanes.

Backing up is always dangerous because it is hard to see behind your vehicle. Use extra caution when backing up.

When following a motorcyclist, allow for at least a three- to four-second following distance. Motorcycles can stop quickly and following them too closely endangers your life and that of the motorcyclist.

Night driving creates a unique set of problems for drivers. Due to the reduced visibility, it can be difficult to judge distance and the traveling speeds of other vehicles when driving at night.

Excessive speed is one of the most common contributing factors to vehicle crashes. Excessive speed does not save time and often leads to high-risk decision-making.

Hydroplaning occurs when there is standing water on a roadway. At speeds up to 35 mph, most tires will channel water away from the tire. As your speed increases past 35 mph, tires cannot channel the water as well and your tires may start to lose contact with the road and ride over the water like a set of water skis.

This sign warns that a steep downgrade is ahead on the road. Drivers should check their brakes.

You should always slow down before entering a curve. You may not be able to see hazards ahead and braking in a curve may cause your vehicle to skid.

This sign informs drivers that they are leaving a divided roadway and approaching a two-way highway.

At a stop sign, you must come to a full stop and check for traffic in all directions before proceeding.

Wherever signs and/or pavement markings permit passing other vehicles, you will have to determine whether or not you have enough space to pass in a safe manner.

If your vehicle begins to skid, release the accelerator or brake pedal to regain vehicle balance. Steer in the direction of the skid to regain control of the vehicle.

A green arrow means “go.” You must turn in the direction the arrow is pointing after you yield to any vehicles, bicycles, or pedestrians who are still in the intersection.

Pennant-shaped yellow signs like this are used to indicate a no passing zone.

Warning signs are usually yellow with black markings. Warning signs may alert drivers to areas where animals, people, and vehicles are likely to cross traffic.

You may never drive off the paved or main-traveled portion of the road and onto the shoulder to pass another vehicle.

If you begin to skid on a wet or icy road, take your foot off the accelerator, stay off the brakes, and turn your steering wheel in the direction of the skid.

While waiting to turn left, keep your wheels pointed straight ahead until it is safe to start your turn. If a vehicle hits you from behind, this will prevent you from veering into oncoming traffic.

If a vehicle merges in front of you too closely, take your foot off of the accelerator. This will create space between you and the vehicle ahead without requiring you to slam on your brakes or swerve into another lane.

Use high beam headlights only when driving in rural areas and when other cars are not nearby. Lower your headlights to their low beam setting when you are following closely behind another driver.

Drivers of trucks, buses, vans, or any vehicles pulling campers or trailers may not be able to see you if you are driving directly behind them. Increase your following distance when driving behind one of these vehicles.

If you block the normal and reasonable movement of traffic by driving too slowly, you may be cited. You should match the speed of traffic, unless the speed of traffic exceeds the legal speed limit.

If you must stop on the shoulder of the interstate or highway, turn on your emergency flashers to warn other drivers and stay inside your vehicle, if you can.

Yellow signs with black markings are used to warn drivers about upcoming hazards or special conditions. Round signs are used only to warn about upcoming railroad crossings.

If you want to enter the freeway but do not see a space for your vehicle in traffic, slow down on the ramp to wait for a gap.

This sign indicates that the road ahead may be slippery when wet.

In foggy or misty conditions, you should not use your headlights on their high beam setting because the light will be reflected back into your eyes.